Upender

Standard 90-degree coil and mold tippers for general industrial use.

Sort by:

All Upender & Tilter Upender Mechanical upender Hydraulic upender Hydraulic Dumper Mold upender Mold Flipper Coil Upender

No products found

No products available in "Upender" category.

View all products →

Technical Insights: Upender

The 90-Degree Workhorse

This category covers the standard 90-degree upender, the most common type found in factories. It consists of a V-shaped cradle (for coils) or a flat L-shaped table (for square loads). The machine rotates 90 degrees to change the load from horizontal to vertical orientation.

Robust Design

Constructed with heavy steel plate and driven by a reliable motor-chain system, these machines are built to last for decades with minimal maintenance.

Frequently Asked Questions

Do I need a pit foundation?

No, most standard upenders are designed to sit on the existing concrete floor. However, for easy forklift loading at ground level, a pit might be required.

Can it stop at any angle?

Typically, they are designed to move between 0 and 90 degrees hard stops. Inverter controls allow for soft start/stop, but holding at 45 degrees is generally not a standard operating mode.